Category: Uncategorized

Five oil separating processes for you to make a note of

admin 16/12/2016

Depending on what construction or manufacturing processes that need to be carried out in your commercial or industrial line, there may invariably be a case for you to be using any one of the following oil separating processes. Perhaps you want to make a note of these for future reference. In the meantime, somewhere down the line, air compressor oil is being used. The five separating processes you could make a note of so long are; the oily separation of pleated air, deep filter air oil separations, a process known as spin on, traditional vacuum separations and the use of natural gas during refrigeration processes.

The pleated air oil separation process is also known as the use of pleated filter media. Filter media is processed via a machine that induces the pleated or wave-like appearance. The deep filter process is commonly using up to three different grades of borosilicate glass, all wrapped in support tubes with the capacity to hold larger than average amounts. Spin on entails a process of resisting pressure. But it remains similar to the processes canned during the use of traditional oil filters.

Oil separators used in vacuum packages are constructed in similar fashion to standard oil separators. They therefore offer similar types of oil removal performances. These separators, however, are designed mainly with flow direction (from outside to inside) in mind. They are, therefore, suitable only for maximum pressure differentials. Where refrigeration (natural) gas processes are concerned, specific inorganic materials are required.

This is necessary for the construction of properly functioning oil separators in refrigeration and natural gas compressor packages. These units without air are compressed and mixed with lubricating oil which must be removed prior to utilizing gas. In these refrigeration processes, natural gasses continue to be utilized.

The sustainable treatment of your wood structures

admin 16/12/2016

If you are still using wood today for all or most of your building and structural maintenance requirements, you ought to be congratulated. This is because you are to a large degree practicing a form of sustainable development. Just as long as your new wood is sourced from areas that have not been designated as protected or endangered and you are, indeed, contributing towards a process of replanting in other areas, you are making an indelible impression on sustaining your living and working environment for the benefit of the generations that will follow you.

While you are building, or re-building, touching up or carrying out necessary maintenance to your domestic, commercial, industrial and agricultural infrastructure, you are necessarily using penta treated wood. You should be congratulated for doing this. Those that haven’t yet ought to make a note of this. The practice of using wood utility poles that have been treated with pentachlorophenol has been around for many years.

It is the most commonly used utility poles and takes up nearly fifty percent of the total market that is utilizing these wood processes. The penta being used is a pesticide. It acts against wood-destroying fungi and insects. The wood has been produced commercially for many years, responding well to its growing demands. Today, it remains highly effective and economical to use. It continues in its ability to control all types of wood-destroying fungus.

The wood also provides protection against termites and powder post beetles. As a sustainable and protected natural tool, it is able to last anything from eight to twenty times longer than it would have without being coated with penta. Penta is applied to the wood through a petroleum oil solution. Properly applied, the solution allows wood to remain treated for many years.